ماژول GPS UBLOX MAX-7Q همراه با آنتن - موقعیت یاب ماهواره ای

The MAX-7Q Evaluation board makes evaluating the high performance of the u-blox 7 GPS/GNSS positioning engine simple. The MAX-7Q Breakout board is very compact, and it’s user-friendly interface and power supply options make it ideally suited for use in laboratories, vehicles and outdoor locations. Furthermore, the MAX-7Q breakout board can be used with a PDA or a notebook PC, making it the perfect companion through all stages of design-in projects. It’s a fully assembled and tested PCB for the u-Blox MAX-7Q with UF.L antenna connectors.

MAX-7Q board features:

u-blox 7 Multi-GNSS engine for GPS/QZSS L1 C/A, GLONASS L1 FDMA, SBAS: WAAS, EGNOS, MSAS

SuperSense Indoor GPS, -162dBm

On-board Ultra low noise 3.3V voltage regulator

I2C (SDA,SCL) and Uart (Tx,Rx)

UF.L antenna connectors

u-center GPS Evaluation Software

Extensive visualization and evaluation features

Supports AssistNow Online and AssistNow Offline A-GPS services

1 TTL UART port, 1 I2C port, One JST 1mm SH connectors 6pin for I2C, UART)

Time pulse LED

I2C eeprom memory on board for settings save inside in the module (can save setings without battery)

Battery for HOT module start

Build-in on board filters, which reduce noise from motor and other high current electronics

Dimensions: 27x16 mm

Weight 2.3 gram

Fully assembled and ready to use

MAX-7Q features:

56-channel u-blox 7 engine

GPS L1 C/A, GLONASS L1 FDMA ,

QZSS L1 C/A,

Galileo E1B/C, Compass ready

SBAS: WAAS, EGNOS, MSAS

Navigation update rate up to 10 Hz

Sensitivity

1.Tracking: –161 dBm –158 dBm

2.Cold starts: –148 dBm –140 dBm

3.Warm starts: –148 dBm –145 dBm

Oscillator TCXO

Built-In RTC crystal

Anti jamming Active CW detection and removal

ROM Memory

Active and passive antenna support